中文 English
首页 / 产品展示 / PWM Buck DC/DC Converter(synchronous)
 
产品展示
PWM Buck DC/DC Co...
PWM Buck DC/DC Co...
LDO
DDR Terminator
MOSFET
PWM Controller
Step-up Converter
Audio Amplifier
Interface Circuit
USB Single Power ...
Battery Management
 
 
 
  • TD8701

  • TD8701  40Vin 4 Outputs Buck Controller

     (DATASHEET)


    TD8701 is a DC/DC Buck Synchronous with four current limit pins suitable for many multi-output applications. It is designed to allow for operating a wide supply voltage range from 9V to 40V. It has both high-side and low-side drivers allowing synchronous configuration using two external power-NMOS. This IC can operate in both Constant Current (CC) and Constant Voltage (CV) modes.
    TD8701 operates as a DC-DC Buck Controller providing a wide range of outputs at Constant Current (CV) from 1.2V to 28V and the output current as high as 10A or above. It has a Constant Current(CC) mode so that output current can be set externally and at a accuracy of +/-7%.
    The current mode control and external compensation makes feedback control have good line and load regulation with flexible external design.
    There are four independent current limit control pins for four separate loads. Each of the current limit can be set by a resistor(RCS) at 100mV across it. Of course, output peak current limit is working during normal operation
    .

    Features

              Vin: 9V to 40V
    Vout: 1.2V to 28V; typical at 5V
    CC/CV Mode Control
    PFM Mode for Increased Light Load Efficiency
    4 outputs current precision OCP: Adjustable Current-Limit Protection  
    Burst mode when OCP/SCP occur
    Protection
    NMOS peak current limit:  accuracy:~10%
    Output short protection: reduce input current to less than 20mA(RMS)
    OVP(output Over-Voltage Protection)
    Output FB short protection
    Temperature shut down(OTP)
    Adjustable Output Cable Resistance Compensation
    Duty: 0~97%
    Switching Frequency: 100kHz to 300KHz 
    Integrated MOSFET Drivers
    QFN20 Package